Table of Contents
Advertisement
SPIDAR Software
Figure 4-3: Project Management screen, showing just one active project
Click the + button to create a new project (you cannot use a name that already exists). A pop-
up window will appear where the project name can be entered (Figure 4-4). Use letters and
numbers only, special characters are not allowed. There is no limit for the number of characters
in the name, however only the first 32 characters are shown in the pop-up window.
Figure 4-4: Entering the name for a new project
On the project page, click the drop-down arrow on the right of a project name to expand the
window and display the number of lines collected for that project. Beside each line number is
the channel (or port) that the receiver antenna was connected to. In the example in Figure 4-5,
a single line was acquired with two receivers: one was connected to Port #1, the other to Port
#7.
23
Advertisement
Table of Contents
