SPX SPIDAR NIC-500s Operation Manual page 25

Operating System: Windows 7 or 10, Android or Linux
Web Browser: Google Chrome (version # 61.0.3163.100 or later)
Display Screen: 10-inch or larger is recommended
Resolution: 1920 x 1200 is recommended
Wireless Connection
To connect wirelessly from the device to the NIC-500, first obtain the name of the NIC-500
network from the LCD display. Then, on the device, search for this name among the Wi-Fi
networks; the Wi-Fi networks may need to refresh once or twice for it to show up. When the
NIC-500 network name appears, select this network and input the password. The default
password is the name of the NIC-500 network. The password is case sensitive. The name and
password can be changed in
NOTE: If the password for the network was forgotten, connect to the NIC-500 with an
Ethernet cable and change the password at this time.
Once connected, open a Google Chrome browser window. In the address bar at the top of the
Google Chrome browser page, type the NIC-500's IP address, which is displayed on the NIC-
500 LCD display. If there are more than one NIC-500, type in the IP address of the Master NIC-
500.
Once connected, the screen in Figure 3-12 will be displayed
NOTE: If you are in SPIDAR SDK mode, you cannot connect wirelessly to the NIC-500.
It must be a wired, Ethernet connect.
Wired Connection
To use a wired connection from the device to the NIC-500, connect an Ethernet cable from the
Ethernet port on the device to one of the Ethernet ports on the NIC-500.
Open a Google Chrome browser window. In the address bar at the top, type the IP address,
which is also found on the NIC-500 LCD display.
Once connected, you will see the screen in Figure 3-12.
Network Settings 4.6.2.
17
Getting Started