SPX SPIDAR NIC-500s Operation Manual page 20

Once completed, move on to
3.1.2 NIC-500P
Up to two pairs of pulseEKKO PRO antennas can be plugged into the pulseEKKO ports on the
NIC-500. These ports are numbered '1', '2', '3' and '4'. Note that ports '1' and '3' should be
used for transmitters and ports '2' and '4' for receivers. In addition, ports '1' and '2' must be
used for a pair, before ports '3' and '4'.
If you are connecting a single pair of antennas, the Tx will connect to port '1' and the Rx will
connect to port '2' (Figure 3-6). See
Once completed, move on to
Figure 3-5: Connecting Noggin cables to the NIC-500N
Powering up in Section 3.4.
Section
Figure 3-6: Single pair of antennas connected to NIC-500P
Powering up in Section 3.4.
8.2 on compatibility.
12
Getting Started