Adjusting The Z Fold Position - Xerox 770 Digital Color Press System Administration Manual

An output sample is printed.
11. Select Close.
12. Check the output sample, and measure the A and B fold position movement amounts.
13. Enter the measurement value you obtained previously in Values A & B Before
Adjustment, and the final value you want after adjustment in Desired Values A & B.
TIP
Set value A and value B so that an edge of the paper does not extend past a
fold position of the paper. An edge of paper extending past a fold position of
the paper may cause a paper jam.
14. Select Sample Printout again to print an output sample, and check the adjustment
results.
15. Make adjustments again if necessary.
16. Select Save.
17. Select Close until the Adjust Fold Position screen appears.
18. Select the tray in which you loaded paper in step 1, and then press the Start button.
19. Select the adjusted fold position type, and select Save.
20. Continue to select Save or Close until you are returned to the main Tools tab display.
21. Exit administrator mode.

Adjusting the Z Fold position

TIP
The C Fold, Z Fold, and Z Fold Half Sheet Fold Positions are available only
when the Standard/Booklet Maker Finisher AND optional C/Z Folder is connected.
NOTE
Adjust Fold Position can be access from three separate areas in Common Service
Settings (Tools/administrator mode):
• Tools > System Settings > Common Service Settings
> Paper Tray Settings > Custom Paper Settings
• Tools > System Settings
> Common Service Settings > Paper Tray Settings > Paper Tray Attributes
• Tools > System Settings > Common Service Settings > Maintenance
1. Load paper in the desired tray.
2. Login as administrator.
3. Access the Tools tab on the UI.
4. Select System Settings > Common Service Settings.
5. Select one of the following:
• Paper Tray Settings > Custom Paper Settings
• Paper Tray Settings > Paper Tray Attributes
• Maintenance > Finisher Adjustment
6. Select Adjust Fold Position.
7. Select Fold Position Type Setup, and select Change Settings.
®
Xerox 770 Digital Color Press
System Administration Guide
System Settings > Common Service Settings
2-51