Paper Tray Attributes > Alignment Adjustment - Xerox 770 Digital Color Press System Administration Manual

c) Select the appropriate settings for 1 Sided-Face Up, 1 Sided-Face Down, and 2
Sided output.
Use the arrow buttons to select the correct amount of curl.
NOTE
Selecting Auto lets the system automatically adjust the paper curl.
d) Select Sample Printout.
Review the sample for paper curl. If the sample printout still continues too much
curl, further adjust the paper curl parameters and print another sample printout.
19. Continue adjusting the paper curl parameters until satisfied with the printouts. Once
a satisfactory printout is achieved, select Save.
The Adjust Paper Curl screen is displayed.
20. Select Close.
The Paper Tray Attributes screen is displayed.
21. Select Close.
The Paper Tray Settings screen displays.
22. Select Close.
The main Tools tab screen is displayed.
23. Exit administrator mode.
Paper Tray Attributes > Alignment Adjustment
1. Load paper in the desired tray.
2. Login as administrator.
3. Access the Tools tab on the UI.
4. Select System Settings > Common Service Settings.
5. Select Paper Tray Settings.
The Paper Tray Settings screen displays.
6. Select Paper Tray Attributes.
The Paper Tray Attributes screen is displayed.
7. Select the desired paper tray.
8. Select Change Settings.
The paper tray setting confirmation screen displays.
9. Select Change Settings.
10. Select Alignment Adjustment.
11. Select Change Settings.
The Alignment Adjustment Setup screen displays.
12. Select Alignment Adjustment Type Setup.
13. Select Change Settings.
The Alignment Adjustment Type Setup screen displays.
14. Select an alignment item (Type 1-20) to set (create) or adjust (revise).
For the purposes of this procedure Type X represents Type 1-20.
15. Select Change Settings.
The Type X screen displays (for example Type 1).
®
Xerox 770 Digital Color Press
System Administration Guide
System Settings > Common Service Settings
2-17