Xerox 770 Digital Color Press System Administration Manual page 69

• Maintenance > Finisher Adjustment
6. Select Adjust Fold Position.
7. Select Fold Position Type Setup, and select Change Settings.
8. Select Z Fold Half Sheet- A3, Z Fold Half Sheet- B4, Z Fold Half Sheet-11x17 , or
Z Fold Half Sheet - 8K, and select Change Settings.
9. Select Sample Printout.
10. Select the tray in which you loaded paper, and press the Start button.
An output sample is printed.
11. Select Save.
12. Check the output sample, and measure the A and B fold position movement amounts.
13. Enter the measurement value you obtained in the previous step in Values A & B Before
Adjustment, and the final value you want after adjustment in Desired Values A & B.
TIP
Set value B so that an edge of the paper does not extend past a fold position
of the paper. An edge of paper extending past a fold position of the paper may
cause a paper jam.
14. Select Sample Printout again to print an output sample, and check the adjustment
results.
15. Make adjustments again if necessary.
16. Select Save.
17. Select Close until the Adjust Fold Position screen appears.
18. Select the tray in which you loaded paper in step 1, and then press the Start button.
19. Select the adjusted fold position type, and select Save.
20. Continue to select Save or Close until you are returned to the main Tools tab display.
21. Exit administrator mode.
®
Xerox 770 Digital Color Press
System Administration Guide
System Settings > Common Service Settings
2-53