Connect The Camera To The Network - Bosch MIC inteox 7100i Installation Manual

MIC inteox 7100i
14.5

Connect the Camera to the Network

Option A (if using a 95 W midspan NPD-9501A):
1. Connect a straight Ethernet cable (Cat5e/Cat6 Shielded Twisted Pair (STP)) from the RJ45
connector of the camera to the DATA + POWER OUT port of the High PoE Midspan.
Note: Do NOT use a cross-over cable!
Note: You must ground cable at both ends!
2. Connect a straight Ethernet cable (Cat5e/Cat6e) from the DATA port of the High PoE
Midspan to the network.
3. If applicable, connect the 24 VAC wires to the power source.
4. If applicable, connect the RS-485 wires to the MIC-ALM-WAS-24 (optional).
5. Attach the ground wire from the camera to an earth-ground connection on the mounting
surface using the supplied screw or a suitable user-supplied fastener.
6. If applicable, connect the AUDIO IN and AUDIO OUT wires to the appropriate line level
audio device.
Option B (if not using High PoE):
1. Connect either a straight or a crossover Ethernet cable (Cat5e/Cat6 Shielded Twisted Pair
(STP)) from the RJ45 connector of the camera to the Local Area Network (LAN) or another
device (a computer, a DVR/NVR, etc.).
Note: You must ground cable at both ends!
2. Connect the dedicated network switch to the RJ45 connector on the computer.
3. Connect the 24 VAC wires to the power source.
4. If applicable, connect the RS-485 wires to the MIC-ALM-WAS-24 (optional).
5. Attach the ground wire from the camera to an earth-ground connection on the mounting
surface using the supplied screw or a suitable user-supplied fastener.
6. If applicable, connect the AUDIO IN and AUDIO OUT wires to the appropriate line level
audio device.
Bosch Security Systems
Installation Manual
Connection | en 51
2022-09 | 2.1 |