Bosch MIC inteox 7100i Installation Manual page 26

26 en | Installing the camera outdoors
How to ground the parapet mount
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Complete the installation of the AUTODOME pipe mount kit per sections 2.6 and 2.7 of
2022-09 | 2.1 |
Install the parapet mount per Section 2.5 of the installation mount, except for the 3/8
inch bolt at the bottom of the mount.
Attach the grounded metal conduit to the parapet and connected to an outdoor rated
metal junction box. Install the junction box as close as possible to the opening at the
bottom of the parapet mount. Note: If you can connect the suppressor to grounded metal
conduit, you can replace the junction box with an outdoor rated surge suppressor.
Attach the ground wire (solid conductor, 8 AWG; labeled 3a in the figure that follows) to
a grounding clamp conduit fitting that is connected to the metal conduit.
Stack the following onto one of the 3/8 inch bolts included with the pendant arm, using
the sequence in the figure that follows (4a - 4c):
- 3/8 inch split washer (labeled 4a in the figure that follows),
- 3/8 inch ring terminal with the other end of the ground conductor crimped in it (labeled
4b in the figure that follows),
- 3/8 inch flat washer (labeled 4c in the figure that follows)
Attach this stack to the bottom hole of the parapet mount. Do not tighten the bolt
completely.
Install a surge suppressor if you did not already install one.
Put the Cat5e/Cat6 shielded Ethernet cable through a waterproof cable gland of the
junction box (or the outdoor rated surge suppressor from step 2) to the sealed, shielded
RJ45 connection of the surge suppressor.
Connect the ground of the surge suppressor per the manufacturer's installation manual.
Put the Ethernet cable from the output side of the surge suppressor through the parapet
pipe.
the parapet mount installation guide.
Installation Manual
MIC inteox 7100i
Bosch Security Systems