Bosch MIC inteox 7100i Installation Manual page 45

MIC inteox 7100i
Figure 13.3: Cant the camera head.
6. Reinsert the screws into both yoke arms. As you tighten the bolts, carefully push the camera
head up about 2 mm (0.08 in.), against gravity, towards the center of the camera (as in the
arrow in the figure that follows). This action removes the slack in the arms and aligns the
screw holes properly so that the camera head can move freely.
Figure 13.4: Push camera head up 2 mm (0.08 in.)
Bosch Security Systems
Installation Manual
(Optional) Canting the Camera | en 45
2022-09 | 2.1 |