Considerations For Mounting The Camera In Inverted Orientation - Bosch MIC inteox 7100i Installation Manual

22 en | Mounting
Figure 5.4: Typical Pole mount configuration
Corner Mount
Figure 5.5: Typical Corner mount configuration
Note: Always install an SCA when you install a wall mount for any installation configuration.
Route cables through the bottom of the SCA (to prevent water from running into the side or
top of the SCA along the cables).
5.4 Considerations for Mounting the Camera in Inverted
Orientation
To change the camera orientation to "Inverted," complete the following steps:
1.
2.
3.
4.
5.
6.
Note the position of the visor when the camera is installed in inverted orientation. The visor
will now be near the body of the camera.
2022-09 | 2.1 |
Remove the camera from the shipping box.
Apply power to the camera.
Access the web browser of the camera.
Access the page Configuration.
Navigate to Camera > Installer Menu > Orientation.
Select "Inverted."
The camera head will rotate automatically into inverted position (180°).
Installation Manual
MIC inteox 7100i
Bosch Security Systems