Furuno FAR-3210 Installation Manual page 75

3) Pass the de-icer power cable through the ca-
ble band. Connect the cable to TB901 on the
DE-ICER board (03P9573), using the sup-
plied crimp-on lugs.
4) Set the Voltage Setting switch according to
the power source for the de-icer; 115 V or
230 V. The default setting is 230 V.
5) Apply power to the de-icer then press and
hold the TEST switch for about ten seconds.
Check that the heater gets hot and then re-
lease the TEST switch.
6) Set the front cover detached at step 1 to the
Antenna Unit. Close the open heater and return to its original position.Take
care not to hit the heater elements on the chassis or radiator.
7) Fasten the two heater elements to the chassis with the four bolts removed at
step 1 on page 2-30). Fasten the base of the heater with two bolts coated with
the supplied adhesive. Fasten the installation materials to each of the cover
bolts.
M5 screw coated M5 screw coated
with adhesive with adhesive
Note: If it is necessary to open the front cover after installing the DE-ICER kit, re-
move the de-icer power cable from the locking wire saddle shown in the following
figure then detach the cover slowly to prevent damage to the heater.
FRONT FRONT
11. Coat the O-ring in the gland for the microwave coaxial cable with silicon grease.
12. Coat the mating surface between the coaxial connector of the cable and the wave-
guide flange on the Antenna Unit with the supplied waterproofing compound.
Note: Do not coat the O-ring with the waterproofing compound.
Remove the de-icer power cable from the locking Remove the de-icer power cable from the locking
wire saddle to open the front cover. wire saddle to open the front cover.
2. WIRING
TB901
Cable band Cable band
M5 screw M5 screw
(Do not apply adhesive.) (Do not apply adhesive.)
Fixing Shaft Fixing Shaft
SD Heater SD Heater
Fixing Plate Fixing Plate
Cover Bolt Cover Bolt
2-33