Control Unit - Furuno FAR-3210 Installation Manual

1.4

Control Unit

The control units can be installed on a desktop or flush mounted in a console. For the
desktop installation the unit can laid flat or tilted.
Installation considerations
Keep in mind the following points when selecting a location.
• Select a location where the control unit can be operated easily.
• Locate the unit away from heat sources because of heat that can build up inside the
cabinet.
• Locate the equipment away from places subject to water splash and rain.
• Leave sufficient space for maintenance and service, referring to the outline draw-
ings at the back of this manual.
Note: The outline drawing number for RCU-024 and RCU-025 is different depend-
ing on the serial number, as shown below:
For RCU-024:
• "199999" or earlier: See "C4473-G02" to "C4473-G04".
• "200001" or later: See "C4473-G18" to "C4473-G20".
For RCU-025:
• "199999" or earlier: See "C3607-G01" to "C3607-G03".
• "200001" or later: See "C3607-G05" to "C3607-G07".
• Determine the location considering the length of the signal cable between the con-
trol unit and the processor unit.
• A magnetic compass will be affected if the control unit is placed too close to the
magnetic compass. Observe the compass safe distances in the SAFETY IN-
STRUCTIONS to prevent interference to the compass.
• Be sure to connect the ground wire (between the earth terminal on the chassis and
the ship's earth).
• Fasten the USB cable with the cable
tie.
1.4.1 Desktop installation
How to mount the unit tilted
Use the desk fixing plate to mount the unit tilted.
1. Fix the desk fixing plate to the bottom of the control unit.
2. Fix the control unit with self-tapping screws (520, local supply).
Ex. RADAR control unit, bottom view
1. INSTALLATION
Cable routing peg Cable routing peg
Cable tie Cable tie
USB cable USB cable
1-13