Synchronization With Ship's Clock - Furuno FAR-3210 Installation Manual

3. SETTINGS AND ADJUSTMENTS
6. When [FWD DIST NM] is different between port and starboard sides, check the
checkbox of [Use different values for Port and Starboard] and then enter each set-
ting value.
7. Click the [Save] button to save the configuration.
3.9

Synchronization With Ship's Clock

The time (UTC) received from the GPS is shown. If the ZDA sentence is input from the
ship's clock, the time synchronized with the ship's clock can be shown.
Do as follows to activate the synchronization with the ship's clock.
Note: The local time setting is not available when the synchronization with ship's clock
is active.
1. In the chart mode, press Ctrl, Shift and t keys simultaneously on the control unit
or keyboard. A dialog box for entry of password appears.
2. Enter the password and click the [OK] button.
Note: The edit mode remains enabled until you press Ctrl, Shift and t keys simul-
taneously or reboot the unit.
3. Click [MENU] to open the menu.
4. Click [Ship & Route Parameters], then click the [Function1] tab.
5. Click the [OFF] button of [Sync with ship's clock] to set "ON".
6. Click the [Save] button to save the configuration.
3-14