Clearaudio Innovation Compact User Manual page 11

User manual
5.)
In the next step remove the lamination of the sensor, mounted on the turntable chassis
(picture 7: red frame).
Please remove the lamination extreme carefully and avoid any soiling and scratches.
Pic. 7: Removing the lamination
6.)
6.1)
Take the platter with both hands (with white gloves) carefully out of the packing.
Please pay attention that the integrated bearing does not fall out of the platter!
The flat side of the platter should face to the chassis and the side with the cut-out (for the record)
should face up.
6.2)
In the next step remove the lamination of the sensor on the bottom side of the platter.
Please remove the lamination extreme carefully and avoid any soiling and scratches.
6.3)
With both hands you can place the platter carefully onto the bearing.
Through a lightly (!!) up and down movement the platter will slip onto the bearing upper part
(picture 8).
Pic. 8: Setting up the platter
Made in Germany
Avoid major side forces to prevent any damages to the
ceramic bearing!
To avoid any damages on your bearing, the platter
should have room temperature before the setup begin
(approx. 20 ° Celsius).
Make sure with gentle pressure that the platter is
applying on the complete surface of the bearing.
Page 11