Mounting The Cross Lath - Barco ELM Series Installation Manual

Mounting the Cross Lath

What has to be A cross lath has to be mounted on the rods. In case the rods run not parallel, the
done rigging points have to be loosen a little.
Necessary Tools A flatblade screwdriver for M5 (No 7) and an Allen Key No 8.
Mounting the To mount the cross lath, follow the next procedure:
cross lath
Illustrations
Image 1
Image 2
BARCO ——————————————————— 8
Step Action
1 Slide the cross lath (A) over the rods.
Important note:
1. If the rods run not parallel, loosen a Little the 3 fixation
screws (C) of the rigging points.
2. Slide the cross lath on the rods until the top of the rods
just suits the front of the lath.
2 Secure the position of the lath with the 2 screws (B). Don’t
forget to fasten the rigging points again.
B
A
A
C
B
————————————— Projection Systems
Image
1&2
1
2
1&2