Event Log - BestCode NExT 8 Series Technical Manual

Event Log

Arrows
Jump to the top of the
active Log page.
Event Opens the Event Log. The Event log tracks all faults, Starts. Stops, and gives an overview of
scripts that the system has executed. This includes Viscosity control adds and SmartFill adds.
Viscosity Opens the Viscosity Log. The Viscosity Log tracks the viscosity of the machine and provides
information of exact viscosity and when Makeup was added to the Ink tank through a viscosity
add.
Phase Opens the Phase Log. The Phase Log tracks the Phase Point, Width, Quality, Accuracy, and
Threshold every minute. Used to diagnose Phase Faults.
Remote Opens the Remote Log. Logs all of the Data send via remote command. Used to verify that data
send to the Printer via Ethernet or Serial matches what was received by the printer.
SmartFill Opens the SmartFill Log. Logs whenever ink levels change. Logs when Ink and Makeup tanks are
low and also when Ink or Makeup is added to the system.
Filter Opens the Filter Log. Logs Filter life, when filter hits less than 250 hours remaining, when filter
life expired, and when new filter is installed.
Upgrade Opens the Upgrade Log. Contains information of the Firmware versions that have been installed
on the device.
Reset Stop
Specific to each Log. Specific to each Log. Stops the Printer from
Deletes all log adding new data entries to the active log. Stop
entries. should be disabled on Remote Log when
running at high data transfer rates.
Save Saves all of the Log files to a USB thumbdrive.
See the troubleshooting section
Video Guide is available here:
BestCode Next Series 8 Technical Manual
Go up 1 entire page on
the active log page.
here for information on the Event Codes.
https://youtu.be/NkP4lz9J9v0
Go down 1 entire
page on the active
log page.
Start
Specific to each Log. Starts the Printer from
adding new data entries to the active log.
October 2022
Jump to the bottom
of the active Log
page.
Page 75 of 290