BestCode NExT 8 Series Technical Manual page 174

Prompt Code Prompt Name
01-0029 Shut Down
Displayed to prompt the user to confirm the request to shutdown the printer, despite the fact that
Auto Clean is enabled.
Solution 1: Press OK to Power Off the Printer.
Solution 2: Press Cancel to close the prompt.
Prompt Code Prompt Name
01-8001 Valve
Displayed to indicate that a valve has failed the valve test.
Press OK to close the prompt. Inspect valve connection and replace if Valve / Valve cable as needed
Solution 1: to resolve.
Prompt Code Prompt Name
01-8002 Power On
Displayed to indicate that the most recent shutdown was due to a power failure.
Solution 1: Press OK to close the prompt. Check Printhead and clean as necessary.
Prompt Code Prompt Name
01-8005 Fault
Written to the event log if a unrecoverable error occurs.
Solution 1: Press OK to close the prompt. Check Printhead and clean as necessary.
Prompt Code Prompt Name
01-8006 Vacuum Leak
Displayed to indicate that a (suspected) vacuum leak has been detected.
Solution 1: Ensure that the Makeup Tank level is OK.
Solution 2: Perform
Prompt Code Prompt Name
01-8007 InitFailed
Solution 1: Hardware on Main PCB is damaged. Replace the Main Board.
Prompt Code Prompt Name
01-8008 InitFailed
Solution 1: Hardware on Main PCB is damaged. Replace the Main Board.
Prompt Code Prompt Name
01-8009 InitFailed
Solution 1: Hardware on Main PCB is damaged. Replace the Main Board.
Prompt Code Prompt Name
02-0001 NO PROMPT
Reports set point of the Fan in Percentage (30%-100%) to the Event Log.
BestCode Next Series 8 Technical Manual
Prompt Description
"Auto Clean disabled while device is off."
Prompt Description
"A valve is bad, Valve X." (X Indicates the failed Valve).
Prompt Description
"Last shutdown due to loss of power."
Prompt Description
"Panic History: %ls"
Prompt Description
"Vacuum leak detected."
Venturi Testing procedure. Inspect Makeup Add lines for loose fittings and clogs.
Prompt Description
"Internal File System initialization failed"
Prompt Description
"USB Interface initialization failed"
Prompt Description
"Network Interface initialization failed"
Prompt Description
Fan speed set to %d."
October 2022 Page 160 of 290