BestCode NExT 8 Series Technical Manual page 172

Prompt Code Prompt Name
01-000F NO PROMPT OCCURS
Written to the event log to indicate that all Counters were in fact reset.
Prompt Code Prompt Name
01-0010 Complete
Displayed to indicate that printing has stopped because a print count has reached the termination
point. Only occurs when
Prompt Code Prompt Name
01-0011 Log Reset
Solution 1: Press OK to Erase the entire Event Log.
Solution 2: Press Cancel to close the prompt.
Prompt Code Prompt Name
01-0012 NO PROMPT OCCURS
Written to the event log to indicate that Event Log was in fact reset.
Prompt Code Prompt Name
01-0013 Log Reset
Solution 1: Press OK to Erase the Viscosity Log.
Solution 2: Press Cancel to close the prompt.
Prompt Code Prompt Name
01-0014 NO PROMPT OCCURS
Written to the event log to indicate that Viscosity Log was in fact reset.
Prompt Code Prompt Name
01-0015 Log Reset
Solution 1: Press OK to Erase the Viscosity Log.
Solution 2: Press Cancel to close the prompt.
Prompt Code Prompt Name
01-0016 NO PROMPT OCCURS
Written to the event log to indicate that Phase Log was in fact reset.
Prompt Code Prompt Name
01-0017 Log Reset
Solution 1: Press OK to Erase the Remote Command Log.
Solution 2: Press Cancel to close the prompt.
Prompt Code Prompt Name
01-0018 NO PROMPT OCCURS
Written to the event log to indicate that Remote Command Log was in fact reset.
BestCode Next Series 8 Technical Manual
Prompt Description
Reset All Counters
Prompt Description
"The print job has reached the end."
"Counter Resets" are set to "Print Off"
Prompt Description
Reset Event Log. Are you sure?
Prompt Description
Reset Event Log.
Prompt Description
Reset Viscosity Log. Are you sure?
Prompt Description
Reset Viscosity Log.
Prompt Description
Reset Phase Log. Are you sure?
Prompt Description
Reset Phase Log.
Prompt Description
Reset Remote Command Log. Are you sure?
Prompt Description
Reset Remote Command Log.
October 2022 Page 158 of 290