Event Messages And Prompt Resolutions (01.06.00.00+) - BestCode NExT 8 Series Technical Manual

Event Messages and Prompt Resolutions (01.06.00.00+)

Prompt Code Prompt Name
00-0001 NOT USED
Solution 1: Updated Firmware Version
Prompt Code Prompt Name
00-0002 PHASE
Displayed when the user touches the phase icon, or its location, pm the main window to show current
phase status: Phase Point, Width, Quality, Efficiency, and Threshold.
Solution 1: Press OK to Leave
Prompt Code Prompt Name
00-0006 USB
Displayed when the user touches the USB icon on the main window to show the version of software
on the currently inserted USB drive (if any).
Solution 1: Press OK to Leave
Prompt Code Prompt Name
00-0007 ENCODER
Displayed when the user touches the Encoder icon, or its location, on the main window to show
current encoder settings.
Solution 1: Press OK to Leave
Prompt Code Prompt Name
00-8001 "An unknown error has occurred"
Displayed when an unexpected error condition occurs. Should never appear.
Solution 1: Contact BestCode Support
Prompt Code Prompt Name
01-0001 Gutter Fault
Perform Backflush Nozzle then start jet, repeat up to 7 times
Solution 1:
Clean the printhead and ensure jet is entering the gutter
Solution 2:
Solution 3: Clogged gutter line. Test valve, gutter detect, venturi, and printhead gutter for clogs or obstructions.
Clean each component and replace if necessary.
Bad jet alignment. Perform nozzle alignment.
Solution 4:
Perform
Solution 5:
Code Name
01-0002 Shut Down
Solution 1: Press OK to Shut Down the machine
Solution 2: Press Cancel to close the prompt.
Prompt Code Prompt Name
01-0003 Message
Solution 1: Press OK to delete the message
Solution 2: Press Cancel to close the prompt.
BestCode Next Series 8 Technical Manual
Prompt Description
Fluid not detected in gutter.
Nozzle Flow Test, check for clogged components.
Description
Are you sure?
Prompt Description
The message will be erased. Are you sure?
October 2022 Page 156 of 290