Table of Contents
Advertisement
•
Front Panel Lockout (Executive Mode)
Front panel lock out prevents the user from changing input selection via the front panel
input buttons. Putting the receiver in lock mode enhances security by protecting against
inappropriate or accidental changes to settings. If a front panel button is pressed during lock
mode, all front panel LEDs blink once.
NOTE: Front panel lockout can only be enabled or disabled via SIS commands (see
Connecting to the USB Port
Connect a USB A to mini‑B cable between the USB Config port on the receiver front panel
and the USB port on a computer.
DTP2 R 212 Front Panel
Figure 14.
Configuration
Enabling Auto‑Input Switching
The DTP2 R 212 can automatically select the active, connected input based on detection
of an active video signal (TMDS clock activity). If two or more inputs are active, the highest‑
numbered input port with an active signal is selected. The Auto Switch priority can be
reversed to lowest active input via SIS commands (see
on page 42) or PCS (see the DTP2 R 212 PCS Help File).
•
•
To enable and operate auto-input switching via the front panel:
1.
2.
Remote control — Inputs can be selected using Extron SIS commands (see
Selection (unsolicited)
on page 42) and PCS (see the DTP2 R 212 PCS Help File).
Front Panel Lockout (unsolicited)
Help File) through the RS‑232 or USB ports.
INPUTS
AUTO
1
2
SWITCH
CONFIG
MODE
NORM / AUTO
USB Port Connection
When auto‑input switching is in effect, the green Auto Switch LED on the front panel
lights and the front panel input buttons are disabled.
When Auto Switch is disabled, the Auto Switch LED does not light.
Press and hold the Input 1 button for 3 seconds.
Press and release the Input 2 button to toggle between Normal mode and Auto Switch
mode.
on page 43) or PCS (see the DTP2 R 212 PCS
Mini Type B
Type A
USB
USB
USB
USB Cable
Ports
INPUTS
OUTPUT
1
2
SIGNAL
HDCP
DTP2 R 212 SERIES
Auto Switch Mode (unsolicited)
DTP2 R 212 Series • Operation
Input
1 2 3 4
WiFi
PC
20
Advertisement
Table of Contents
