Lockit Lacing Brackets - Extron electronics DTP2 R 212 Series User Manual

Hdmi dtp2 receiver and switcher with audio de-embedding

Hide thumbs Also See for DTP2 R 212 Series:

Table of Contents

LockIt Lacing Brackets

Use the included LockIt lacing brackets to securely fasten the HDMI cables to each device

as follows.

ATTENTION:

Plug the HDMI cable into the rear panel connection.

Loosen the HDMI connection mounting screw from the

panel enough to allow the LockIt lacing bracket to be

placed over it. The screw does not have to be removed.

Place the LockIt lacing bracket on the screw and

against the HDMI connector, then tighten the screw to

secure the bracket.

•

Do not overtighten the HDMI connector mounting

screw. The shield it fastens to is very thin and can

easily be stripped.

•

Ne serrez pas trop la vis de montage du

connecteur HDMI. Le blindage auquel elle est

attachée est très fin et peut facilement être

dénudé.

Loosely place the included tie wrap around the HDMI

connector and the LockIt lacing bracket as shown.

While holding the connector securely against the lacing bracket, use pliers or similar

tools to tighten the tie wrap, then remove any excess length.

1 1 1

3 3 3

4 4 4

5 5 5

DTP2 R 212 Series • Installation

2 2 2

Table of Contents