Table of Contents
Advertisement
INSTALLATION OF VEHICLE UPPER ANCHOR POINT
For vehicles other than Sedans - In Australia, consult your nearest child restraint fitting
station or traffic authority for vehicle inspection to find the best, correct position for the
placement of the upper anchorage point, and for the correct attachment bolt length and
use of spacers. In New Zealand, consult the agent for the vehicle. Note to Queensland
purchasers: The installation of anchorage points must be approved by authorised officers
appointed by Queensland Transport. Authorised officers can be sourced from all Queensland
Transport Customer Service and Queensland Ambulance Service Centres.
NOTE: Marking on
the top of a Grade 5
Bolt. Do not use any bolt
without these marks.
Centre line of
Fig.3.
seating position
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE
BOLT IS NOT THE CORRECT LENGTH THE
CAR MANUFACTURER'S HAND BOOK CAN
PROVIDE ADVICE ON THE CORRECT LENGTH
BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED
200mm
TO UNSOUND METAL OR TO WOOD, OR
min.
SYNTHETIC STRUCTURES. WHEN DRILLING
9 MM HOLE DO NOT DRILL THROUGH FUEL
LINES, FUEL TANKS, ELECTRICAL WIRING, OR
RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED
FROM SHARP CORNERS AND EDGES. THE
ANCHOR FITTING MUST BE USED ONLY
AS DESCRIBED ABOVE. IT MUST NOT BE
HOOKED ONTO ANY OTHER OBJECT.
Instructions for Installation & Use
85
Advertisement
Table of Contents
