Muse M-1150 BT - Bluetooth Speaker With PLL Radio Manual

UNPACK YOUR UNIT

When you unpack your new unit, make sure that you have removed all the accessories and information papers:

• Speaker tower
• AC adaptor
• User manual
• 1 piece of Stereo audio connection cable with 3.5 stereo plug
• 2 pieces of Assembly screws / washers

INSTALLATION

1. Loud Speakers
2. Base
3. Screws
4. Washers
5. Speaker Net

Assembled the wooden base to the main body by the supplied screws and washers. The speaker net can take out and reassemble.

LOCATION AND DESCRIPTION OF CONTROLS

MAIN UNIT

1. MODE indicator
2. AUX input jack
3. USB PLAY / USB CHARGE port
4. SOURCE button
5. STOP button
6. Standby Button
7. Play/Pause Button
8. VOL- Button
9. VOL+ Button
10. / TUNE+ Button
11. / TUNE- Button
12. FM Antenna

POWER SUPPLY

USING THE AC ADAPTOR

• The supplied AC adaptor operates on AC mains supplies of 100-240V~50/60Hz and should only be connected to a mains supply within these parameters.
• Use the supplied AC adaptor only. Using any other AC adaptor could damage the unit.

• The included AC adaptor is for use with this unit only. Do not use it with other equipments.
• When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.
• Be sure to use it near the wall outlet. If a malfunction occurs, disconnect the plug from the wall outlet at once.
• When the AC adaptor is plugged in, the apparatus is not completely disconnected from the main power source, even when the unit is turned off.
• AC adaptor is used as the disconnect device. It shall remain readily operable and should not be obstructed during intended use. To be completely disconnected the apparatus from supply mains, the AC adaptor of the apparatus shall be disconnected from the mains socket outlet completely.

GENERAL OPERATION

1. Press button to turn on or turn off the unit.
2. Press the SOURCE button repeatedly to select the playback source as desired. The STANDBY indicator will turned the color as below:

3. Press the VOL+/- Buttons to adjust volume level.

Note: If no source is played, the unit will go to standby mode automatically after 2 hours.

PLAY RADIO

Manual Search

1. Press the button to turn on the unit.
2. Press SOURCE button repeatedly until the Indicator color turns to green.
3. For best reception, extend the FM wire antenna.
4. Choose your radio station with TUNE- or TUNE+.

Automatic Search

Press and hold for few seconds TUNE- or TUNE+. The automatic search locates strong stations. A station with a weak signal can be set manually by repeatedly pressing TUNE- or TUNE+.

NOTE: During the search operation, the sound level is automatically muted.

USB PLAYBACK

You can connect a USB flash drive (not included) to the USB port on the unit to play MP3 files.

1. Press button to turn on the unit. Press the SOURCE button repeatedly until the color of Indicator turns to light blue. Wait a few seconds, the unit will play the music files automatically.
2. Press to suspend momentarily the playing track. Press again to resume playing.
3. Press button to skip forward to next track and to skip backward to previous track. Press and hold or to search quickly within a track.

Note:

• The unit is compatible with the following Memory Device (Source): USB flash drive.
• Supporting format: MP3 (32kbps-320kbps)
• The total number of MP3 files on the Memory Device should not exceed 999.
• For playing files on USB flash drive, you should plug in the USB flash drive when the unit is in standby mode. Turn ON the unit and use SOURCE button to select USB mode.
• There are many USB devices in the market. We cannot guarantee to support all different models. Please try another USB device if your device is not supported.

LISTENING TO AUXILIARY SOURCE

1. Connect your auxiliary source (e.g. iPod / iPad / MP3 player) to the AUX jack (3.5mm ).
2. Press the button to turn on the unit. Press the SOURCE button repeatedly until the color of indicator turns to Purple.
3. Start playback from your auxiliary source.
4. Adjust the volume to desired level.
5. To stop playback, disconnect your auxiliary source from the AUX jack.

USB CHARGER-A Power USB Port

Connect your device to USB cable (not included) and plug the standard USB plug into the USB charging port on the top of the unit.

NOTES:

• The maximum output from the USB charging port is DC 5V, 2.1 A. You can charge any rechargeable USB devices charging current less than it, such as iPod, iPhone, iPad, MP3 Player...etc.
• Charging function is available in Standby mode. Charging function is not available in USB mode.
• Some devices may be incompatible.

BLUETOOTH PAIRING & LINKING OPERATION

The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by New One S.A.S is under license. Other trademarks and trade names are those of their respective owners.

1. Turn off the Bluetooth functionality of other devices that were paired with your unit.
2. Press button to turn on the unit.
3. Press SOURCE button to select Bluetooth mode, blue light will be showed on indicator. Your unit will be in pairing mode with a tone voice.
4. Turn on Bluetooth functionality on your Bluetooth device. Typically, Bluetooth controls are found on the device's tools or settings menu (see your user manual). Turn on Bluetooth connectivity and make your device "discoverable".
5. Clean out the paring list on your Bluetooth device.
6. Choose "add a new Bluetooth device" or "setup Bluetooth device" on your device. It will start to search. Once "M-1150 BT" shows on your device, select it. If your device prompts you for a pass code, please enter 0000. If the pairing attempt fails or times out, please start pairing procedure again (see steps 2-6).
7. After your device and the "M-1150 BT" have connected each other, a tone voice can be heard, and the indicator stay lit.

Play MUSIC from Bluetooth devices

Make sure the Bluetooth connection between the unit and the device is active.

1. Press to suspend momentarily the playing track. Press again to resume playing.
2. Press button to skip forward to next track and to skip backward to previous track.

Note: and buttons may not work with some of the players in your Bluetooth source.

Hereby, NEW ONE S.A.S, declares that this MUSE M-1150 BT is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/ EC. The declaration of conformity may be consulted at http://www.muse-europe. com/conformity/M-1150BT.pdf

TROUBLESHOOTING GUIDE

Symptom	Cause	Solution
No power	AC adaptor not plugged into wall outlet.	Plug it to the wall outlet properly.
	The unit is in Standby mode.	Press the button to turn on the unit.
No sound	Volume in minimum.	Adjust volume to a desired level.
	The connected device is not in playback mode.	Play the music in the connected device.
	Sound output of the connected device weak. (AUX IN & BLUETOOTH mode)	Adjust volume of connected device.
Sound distortion	Volume level too high	Reduce the volume level by press the VOL- button.
	Volume level of the connected device too high. (AUX IN & BLUETOOTH mode)	Reduce the volume level of the connected device.
Bluetooth reception failure	Not in the Bluetooth mode.	Try to do connection again.

• Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other, a grounding type plug has two blades and a third grounding prong, the wide blade or the prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
• Only use attachments / accessories specified by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
• Do not overload wall outlets and extension cords as this can result in a risk or fire or electric shock.
• When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may resu in fire or electric shock or other hazards.

SPECIFICATIONS

Power source: DC 12V 2.5A

Radio Coverage: FM 87.5 -108.0 MHz

Impedance of Speakers: Loud speakers 6 Ohm x 2

Bluetooth: 2.402-2.48GHz

RF Output Power: 4 dBm

Bluetooth working distance: Up to 10 meters measured in open space. (Wall and structures may affect range of device)