Specifications - Projecta INTELLI-CHARGE IC25 Manual

FAULTS & ERRORS
There are six error codes that may be displayed. These will be displayed in the
following way:
LCD Power On LED
Err Slow Flashing
F01 Fast Flashing
– Slow Flashing
OTP Fast Flashing
OLC Fast Flashing
OCP Fast Flashing

SPECIFICATIONS

P/No.
Type
Input (nominal)
Input Power
Output Voltage
Output Current
Minimum Start Voltage 1.0V
Back Drain
18
IC25, IC25W, IC25RV
7/5 stage
230-240VAC, 50Hz
450W
12V
2, 6, 12, 25A
3mA
Fault
Short circuit or reverse
connection of the clips
Bulk charging has
timed out and stopped
after 22 hours
The charger has
entered recondition
mode 3 times and
has timed out
The charger has
overheated and has
switched off
Sensor wires are not
connected to the
positive/negative
connections
The charger has
encountered an error
IC35 IC50
7/5 stage 7/5 stage
230-240VAC, 50Hz 230-240VAC, 50Hz
570W 820W
12V 12V
2, 8, 16, 35A 2, 6, 12, 25, 50A
1.0V 1.0V
3mA 3mA
Remedy
Check clips are not
touching each other
OR
Check the clips are
correctly connected
to the battery
Battery may be faulty
Battery may be faulty
and may need replacing
OR
There is a load on the
battery causing the
battery to fail Analysis
Ensure adequate
ventilation around
the charger
If DC leads have been
cut for hardwiring, check
sensor wires are included
in both positive & negative
connections (Refer
to page 13, point 1)
Contact Brown & Watson
International
IC8-24
7/5 stage
230-240VAC, 50Hz
270W
24V
2, 4, 6, 8A
2.0V
3mA