Ospf > Configuration > Network Area - Lantronix SISPM1040 L3 Series Web User Manual

Layer 3 managed hardened poe + switch

Hide thumbs Also See for SISPM1040 L3 Series:

Table of Contents

SISPM1040-xxxx-L3 Web User Guide

OSPF > Configuration > Network Area

This page lets you set OSPF area parameters. It is used to specify the OSPF enabled interface(s). When OSPF is

enabled on the specific interface(s), the router can provide the network information to the other OSPF routers via

those interfaces.

Delete: Check to delete the entry. It will be deleted during the next save.

Network Address: IPv4 network address.

Mask Length: IPv4 network mask length.

Area ID: The OSPF area ID.

Add New Entry: Click to add new entry.

Apply: Click to save changes.

Reset: Click to undo any changes made locally and revert to previously saved values.

Messages: The entry {Network Address:0.0.0.0, Mask Length:24} address range overlaps with {Network

Address:0.0.0.0, Mask Length:24}.

33856 Rev. A

https://www.lantronix.com/