Table of Contents
Advertisement
I/O Shield Connector
PS/2
Mouse
PS/2
Keyboard
COM1
Power-On/Off (Remote)
Note: For maintaining the DDR SDRAM power during STR (ACPI S3) function, it is
strongly recommended to use power supplies that have a +5VSB current of (>
=) 2A. Please check the 5VSB’s specification printed on the power supply’s
outer case.
Note: The board requires a minimum of 250 Watt power supply to operate. Your
system configuration (amount of memory, add-in cards, peripherals, etc.) may
exceed the minimum power requirement but to ensure that adequate power is
provided, use a 300 Watt (or greater) power supply.
PW-ON
Case (chassis) Power ON/OFF button (PW-ON)
Figure 4: Simple ATX power ON/OFF controller
Parallel Port
VGA1
USB2.0
ports
Figure 3: I/O ports
Remote On/Off
RJ-45 LAN
(Optional)
Line-in/Rear out (Blue)
Line-out/Front out (Green)
Mic-in/Center&Subwoofer (Pink)
USB2.0
ports
20-pin
Introduction
®
POWER SUPPLY
Page 1-5
Advertisement
Table of Contents
