Battery Charger Connector; Dc-In Connector; Figure 20: Battery Charger Connector Diagram; Figure 21: Dc-In Connector Diagram - VIA Technologies VAB-950 User Manual

3.4 Battery Charger Connector
The VIA VAB-950 is equipped with a battery charger connector labeled as 'BAT1' which is used for charging the
rechargeable lithium battery. The pinouts of the battery charger connector are shown below.
Figure 20: Battery charger connector diagram
Pin Signal
1 BAT+
2 BAT+
3 I2C_CLK
4 I2C_DATA
5 TH
6 BAT-
7 BAT-
Table 10: Battery charger connector pinouts
3.5

DC-in Connector

The VIA VAB-950 comes with a DC-in connector that carries a 12V DC which provides power to the board. The
DC-in connector is labeled as 'J3'. The pinouts of the DC-in connector are shown below.

Figure 21: DC-in connector diagram

Pin Signal
1 12VIN
2 GND

Table 11: DC-in connector pinouts

VIA VAB-950 User Manual
13