To Remove And Replace The Touch-Screen Controller Board - Agilent Technologies 16900A Service Manual

6
Replacing Assemblies

To remove and replace the touch-screen controller board

T6 Screw
66
1 Perform previous procedures:
• "To prepare the instrument for disassembly"
page 48
• "To remove and replace the cover"
• "To remove and replace the front panel assembly"
page 64
2 Place the front panel assembly face down and disconnect
the cables from the touch- screen controller board as
shown.
Using a Torx T6 screwdriver, remove the 2 screws
3
securing the board to the front panel board.
Touch-Screen
Controller Board
8-Wire
Touch-Screen
Cable
on page 52
T6 Screw
Touch-Screen
Cable Assembly
Jumper
16900A, 16902A, and 16903A Service Guide
on
on