To Remove And Replace The Front Panel Assembly - Agilent Technologies 16900A Service Manual

6
Replacing Assemblies

To remove and replace the front panel assembly

16900
Chassis
T10
Screws (4)
Power
On|Off
Cable
64
1 Perform previous procedures:
• "To prepare the instrument for disassembly"
page 48
• "To remove and replace the cover"
Disconnect the following cables from the module interface
2
board:
• Front panel cable (16902/03A only)
• Power On|Off cable
• CD- ROM cable
3 Using a Torx T10 screwdriver, remove 4 screws that
secure the front panel to the chassis.
Remove/replace the front panel assembly.
4
Module
Interface
Front
Board
Panel
Cable
CD-ROM
Cable
Alignment
Pin
Reverse this procedure to install the front panel assembly.
5
T10
16902/03A
Screws (4)
Chassis
Power
On|Off
Cable
16900A, 16902A, and 16903A Service Guide
on
on page 52
Module
Interface
Board
CD-ROM
Cable
Alignment
Pin