Call Transfer; Transfer To Engenius Handset; Transfer To Pbx Extension - EnGenius FreeStyl SIP User Manual

e. Delete group selections by pressing
followed by 2 to Unsubscribe the group.
Notes:
1. The handset can change group affiliations at any time.
2. The base station is not responsible for group assignments.
Consequently, it cannot de-subscribe a handset from a group.
3. When an intercom caller enters a group ID, all handsets subscribed to
this group will ring. The first handset to answer will establish a link
with the caller. Afterward, it is a one-to-one call, not a one-to-many
call.

Call Transfer

 Transfer to EnGenius Handset
While a telephone call is in progress, you can transfer it between different
handsets.
Direct Transfer (Unannounced Transfer )
1. Press OPTION (Right) soft key, followed by the
the call on hold.
2. Press XFER (Right) soft key, followed by entering the
destination handset ID, then the held call will be transferred
directly.
After the call is transferred to the destination handset, the
original handset will go back to standby mode automatically.
Ex. While on a call, press OPTION, ＊(to hold call), then
enter HS ID (selected handset to transfer call to), Call
Transfer Paging Ext message will appear, once handset
11 answers, Transferee HS 10 will hang up
automatically.
OPTION soft key
key to put
＊
~41~
If HS 11 does not answer to the transfer, After 8 rings, it
will transfer back to the transferee HS 10 with a unique
transfer ring tone.
Indirect Transfer (2-way Announced Transfer)
If you want to talk to the destination handset before the call is
transferred, you can follow the below method:
1. During the call, press
key, then enter the destination
handset ID.
2.
Press the of the destination handset to answer the
intercom call, you can now talk to the destination handset.
After talking, press to end the intercom call, and then
the destination handset is able to pick up the incoming call
automatically.
After the call is transferred to the destination handset, the
original handset will go back to standby mode automatically.
PS: If HS 11 Decides to take the call, Transferee HS 10 will
need to press key for the call to transfer to HS 11.
HS 11 Decides NOT to take the call, requested HS 11 will
need to press Key to end 2-way and deny transfer,
call will go back to HS 10.
Notes: If the destination handset does not answer after paging it or
transferring timeout, the call is routed back to the originating handset.
 Transfer to PBX Extension
While a telephone call is in progress, you want to transfer it to another extension
(not an EnGenius handset). This kind of operation is similar to use ATA device.
Call Transfer
~42~