EnGenius FreeStyl SIP User Manual page 11

c. Dial from display.
d.
During the stand-by mode, you can enter the phone book by pressing
the scrolling key.
e. Phone Book transfer via air
i. Transfer a specific Phone Book to one handset or all registered
handsets
ii. Transfer all Phone Books to one handset or all registered handsets
15. Key Tone
a. Four-level Key Tone volume selections (Off/Low/Medium/High).
b. Four Key Tone type selections.
16. Call Timers
a. Displays call time duration for current call, during and immediately after
the call.
17. Programmable Feature Call
a. Allows user to pre-program the most frequently used Feature codes into
the FreeStyl SIP, which is adjunct to the PBX system.
b. Up to 10-entries can be saved.
c. Once the feature code has been programmed, you can quickly perform
those functions during the call by pressing the
18. Menu Display
a. To avoid mis-setup in the "Call Settings"(MENU-4), "Phone Settings"
(MENU-5), and "Base Settings" (MENU-6), these settings can be hidden.
b. The Handset password is required before entering Menu Display (MENU-
8), the default handset password is "0000."
c. When disabling the settings, they will no longer be displayed unless
enabled by entering Menu Display again.
19. PA On/Off
a. Enable or disable the Broadcast function.
When PA is Off, the handset cannot receive Broadcast from the base
b.
station or other registered handsets; but it can broadcast to other
registered handsets.
20. Group Setting
a. Allows the handset to subscribe to one or several groups.
Re: Up to 7 groups (1~7) can be subscribed.
OPTION soft key.
~21~
21. Custom Name
a. Change the "FreeStyl SIP" screen to the desired wording or info, such as
the handset user's name.
Re: Up to 32-characters can be entered.
22. Change Pwd
a. MENU -5 (Phone Settings)-8 (Change Pwd), enter original password
(default： 0000), then enter new password.
23. DTMF Duration (from web)
24. Programmable Flash Key Timing (from web)
25. Assign Next Handset ID for New Handsets
a. Use a registered handset from MENU-6-1 to assign a Next Handset ID to a
new handset.
b. If you do not assign Next Handset ID, the system will automatically assign a
handset ID to a new handset.
c. When entering the Base Settings, a PIN is required. The Default is "0000."
26. Clear Handset
a. Use a registered handset from MENU-6-2 to remove the other registered
handset, in case the other registered handset is defected.
b. Once the other registered handset is clear, the user is able to register a
new handset in its place.
c. When entering the Base Settings, the PIN is required. Default is "0000."
27. Change PIN
To change the base PIN, enter the "Base Settings" (MENU-6-3).
a. Use a registered handset to change the PIN from MENU-6-3.
b. The default PIN is "0000."
c. When entering the Base Settings, the PIN is required. The default PIN is
"0000."
28. Mic Gain
Change the handset microphone gain based on the handset's use in different
environments – Quiet, Normal and Noisy environment.
a. This requires entering the "Phone Settings" (MENU-5-1).
29. Headset Ring
Change the ringer emitting either from the handset speaker or the headset
receiver.
~22~