General Safety Instructions - Bosch rexroth CP1 Instruction Manual

Safety instructions | Control panels CP1 and CP2 |
2�5 General safety instructions
• Observe the country-specific accident prevention and environmental protection
regulations.
• Observe the safety regulations of the country in which the product is
used/operated.
• Use Rexroth products only when they are in good working order.
• Do not install, operate, disassemble or maintain Rexroth products if under the
influence of alcohol, drugs or medication that may affect your reaction time.
• Only use approved accessories and original spare parts from Rexroth in order to
exclude hazards to persons due to unsuitable spare parts.
• Observe the technical data and ambient conditions specified in the product
documentation.
• If unsuitable products are installed or used in applications that are of relevance
to safety, unexpected operating conditions may occur in the application,
which could result in personal injury or property damage. For this reason,
only use the product in safety-relevant applications if this use is expressly
indicated and approved in the product documentation, e.g. in safety-related
parts of a control system (functional safety).
• Only commission the product if it has been determined that the end product
(e.g. machinery/system) in which the Rexroth products are installed complies
with the country-specific provisions, safety regulations and standards for the
application.
• Use tools appropriate for the work being performed and wear appropriate
protective clothing to prevent punctures and cuts (e.g. when removing protective
covers, disassembly).
• This control panel contains electronic components and may thus be
damaged by electrostatic discharge. Comply with the handling regulations
for electronically sensitive components, see respective data sheet
(Table 1 "Required and supplementary documentation" on page 4).
• The proposed circuits do not imply any technical liability for the system or the
machine on the part of Bosch Rexroth.
• It is not permissible to open the control panel or to modify or repair the
control panel. Modifications or repairs to the wiring could result in dangerous
malfunctions.
• The control panel may only be installed/disassembled in a de-energized state.
• Only trained and experienced specialists who are adequately familiar with
both the components used and the complete system should implement system
developments or install and commission electronic systems for controlling
hydraulic drives.
• The machine may pose unforeseen hazards while the control panel is being
commissioned and serviced. Before commissioning the system, you must
therefore ensure that the vehicle and the hydraulic system are in a safe condition.
• Make sure that nobody is in the machine's danger zone.
• Do not use defective components or components which are not in
a proper working order. If components fail or demonstrate a faulty operation,
they must be replaced.
RE 95259-01-B/2021-11-09, Bosch Rexroth AG
9/24