Advertisement
General Safety Instructions (Cont.)
Ventilation requirements
• Heat, steam and moisture will be created during use of the oven. Take care
to avoid injury and ensure the room is adequately ventilated.
• If the appliance is going to be used for prolonged periods of time, additional
ventilation may be required. If in doubt about your ventilation requirements,
consult your qualified installer.
• To reduce the risk of fire, do not install this oven in an area where the
ventilation or circulation ducts may become blocked.
Electrical connection
• Ensure there is an earthed socket nearby.
• A dedicated power circuit is recommended for the unit but not required.
Additional electrical appliances on the same circuit may exceed the current
(amperage) rating for that circuit. If after the installation of your oven the
circuit breaker trips or the fuse fails on a repeated basis, then a dedicated
circuit will likely be required.
• The unit's power cord must be connected to a properly grounded and
protected, 240V ~ electrical outlet. Always use ground fault protection where
required by the electrical code.
• The mains socket must be within easy reach so that the plug can easily be
removed if necessary.
• After installation the appliance must be able to be disconnected by an
accessible plug or a switch in the fixed wiring.
• The outlet voltage and circuit frequency must correspond to the voltage
stated on the appliance rating label.
Power cord
• To reduce the risk of fire, avoid running the power cord under rugs, carpets,
etc. Keep it away from high traffic areas where it may pose a tripping hazard.
• Do not allow electrical fittings or cables to come into contact with areas on
the oven that get hot. Do not let the cord touch hot surfaces during use. Do
not kink, squash or strain the power cord and protect it from sharp edges
and heat.
• Regularly check the power cord for damage. If the supply cord is damaged,
it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard or injury.
• Do not connect the appliance to an extension cord or plug adaptor, which
may overheat and cause a fire.
• If winding the power cord, avoid tight bends as this could damage the cord.
4 4
(AU) 1300 886 649 (NZ) 0800 836 761 |
After Sales Support
tempo.org/support
Advertisement
