General Safety Instructions IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY AND KEEP FOR FUTURE REFERENCE Read this manual thoroughly before first use, even if you are familiar with this type of product. The safety precautions enclosed herein reduce the risk of fire, electric shock and injury when correctly adhered to.
Page 4
General Safety Instructions (Cont.) Ventilation requirements • Heat, steam and moisture will be created during use of the oven. Take care to avoid injury and ensure the room is adequately ventilated. • If the appliance is going to be used for prolonged periods of time, additional ventilation may be required.
Page 5
General Safety Instructions (Cont.) • Winding the cord: If winding the power cord, avoid tight bends as this could damage the cord. General usage conditions and restrictions • Domestic use only: This oven is designed for indoor domestic use only. It can be built into a standard kitchen cabinet or housing unit.
Page 6
General Safety Instructions (Cont.) • WARNING! Disconnect: Remove the power plug from the electrical socket in the following situations: * Before changing the lamp to avoid the possibility of electric shock. * Before any adjustments, service or maintenance work is done on it. Grip the plug when disconnecting, do not pull on the cord.
Page 7
General Safety Instructions (Cont.) • Cleaning: Clean the oven on a regular basis so oils and fats do not accumulate and cause a fire risk. Make sure all relevant oven controls are switched off before cleaning. Refer to pages 21–23 for comprehensive cleaning instructions.
Product Overview Scope of delivery Oven Control panel (see page 9) Oven interior Oven light (inside oven, not visible) Shelf supports (side racks) (inside oven) Oven door (reversible) After Sales Support (AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support...
Page 9
Product Overview (Cont.) Control panel STOP Control panel Accessories FUNCTION control TIMER control TEMPERATURE control Accessories Oven rack Baking tray insert Baking tray Other inclusions (not shown) 2 Screws (for installation) Instruction manual Warranty certificate NOTE: Due to continued product improvement, images and illustrations in this manual may vary slightly from the product purchased.
Installation Installing the oven into a kitchen cabinet General Tolerances: Width: 560 ± 1.5 mm Product dimensions Height: 589 ± 2.5 mm Product dimensions Aperture dimensions Height: 595mm Height: 589mm Width: 595mm Width: 560mm Depth: 560mm Depth: 550mm (min.) Space requirements •...
Page 11
Installation (Cont.) Ventilation requirements Fig. 1 • When mounted under a benchtop, airflow ventilation is important to help keep the cabinets and oven electronics from getting too hot (Fig. 1). • The location of the power point cannot be mounted directly behind the oven as this will impede the oven sitting correctly into the...
Page 12
Installation (Cont.) Electrical connection WARNING! All electrical work must be carried out by a licensed electrician. No alterations or wilful changes in the electricity supply should be carried out. • This oven is manufactured to work with single-phase alternating current (220–240V~ 50–60Hz).
Getting Started Unpacking the appliance • This product has been packaged to protect it against transportation damage. Unpack the appliance and remove all packaging materials from around the oven and from inside the oven cavity. • Keep the original packaging carton and materials in a safe place. It will help prevent any damage if the product needs to be transported in the future, and you can use to store the appliance, if required.
Instructions Switching the oven on and off • To switch off the oven, set both FUNCTION and TEMPERATURE control knobs to the OFF [ o ] position. Selecting a function and temperature TIMER STOP FUNCTION TEMPERATURE Selecting an oven function Use the FUNCTION control knob to select your required oven function.
Page 15
Instructions (Cont.) Symbol Function / cooking mode Oven light This function provides a separate light control to illuminate the oven cavity without opening the door. It will light up for all cooking functions. Defrost (with Fan) STOP This function circulates room temperature air to thaw frozen food STOP more quickly, without the use of any heat.
Page 16
Instructions (Cont.) Timer Functions Fig. 4 Cook time Countdown Time display indicator indicator STOP End time Time indicator indicator Down Mode Button Button Selection Button Selecting a Timer Function STOP STOP • When a function has been selected, the corresponding function indicator will flash for approx.
Page 17
Instructions (Cont.) Switching On the Time Display • Hold down any button until the time reappears in the display. NOTE: The display can only be switched off if none of the clock functions COOK TIME [ ], END TIME [ ] or COUNTDOWN [ ] are in use.
Page 18
Instructions (Cont.) STOP Setting the End Cook Time Function • Press MODE [ ] button repeatedly, until the END COOK TIME indicator ] flashes. STOP • Using the UP and DOWN buttons, set the required switch-off time. • After approx. 5 seconds, the display will return to the current time, and the END COOK TIME indicator [ ] will light up.
Page 19
Instructions (Cont.) Shelf positions • Your oven comes supplied with an oven rack and a baking tray, which can be positioned on the side racks (shelf supports) at the sides of the oven cavity (Fig. 5). • When installed correctly, the oven rack and baking tray should be horizontal and not at an angle.
Page 20
Instructions (Cont.) Cooking and baking tips • Before switching on: Before cooking, check that any accessories that are not required are removed from the oven and that only the baking tray and/or the oven rack are positioned on the appropriate shelf support(s). •...
Page 21
Instructions (Cont.) Saving energy Using energy in a responsible way not only saves money but also helps the environment. Below are a few hints how you can save energy when using your electric oven. • Do not open the oven door more frequently than required. •...
FAQs and Troubleshooting Guide If you experience problems with your oven, or it appears to be operating incorrectly, check on the following pages for solutions to common problems. The oven isn’t coming on. • Ensure that the oven is properly connected to the electricity supply. •...
Page 23
FAQs and Troubleshooting Guide (Cont.) • Do not leave food in the oven to cool after it has been cooked and the oven has been switched off. • Use a covered container, where practical, when cooking to reduce the amount of condensation that forms. The fan keeps on running although the oven is switched off.
Other Useful Information Cleaning the oven CAUTION! • Before cleaning any part of the oven, make sure all oven controls are switched off and the oven has cooled down sufficiently. • Never use a steam cleaner to clean any part of the oven. •...
Page 25
Other Useful Information (Cont.) Removing the oven door for cleaning Removing the oven door and the glass panel inside the door enables full access to the entire oven cavity for easier cleaning and maintenance. • Before you start, place some soft, padded material on the floor or benchtop. •...
Page 26
Other Useful Information (Cont.) Removing the door’s inner glass panel for cleaning IMPORTANT: Do not use any abrasive cleaner that could cause damage. Remember that if the surface of the glass panel becomes scratched, this could lead to a dangerous failure. While you have the oven door removed for cleaning, you may wish to remove the inner glass panels for cleaning.
Page 27
Other Useful Information (Cont.) Reversing the door opening direction • Open the door to the angle Fig. 12 shown (Fig. 12). • Unscrew screw 1 with screwdriver 3, push screw 1 downward, and then pull the door out from up fixed support (Fig.
Page 28
Other Useful Information (Cont.) • Screw up 1 and screw off Fig. 16 2 (Fig. 16). • Prepare to assemble the door to opposite door spindle. At this moment, screw 1 is downward, screw 2 is upward (Fig 17). Fig. 17 •...
Page 29
Other Useful Information (Cont.) Replacing the oven light bulb IMPORTANT! To avoid the possibility of electric shock, make sure the oven is switched off and unplugged from the power supply before removing or replacing the oven light bulb. When the lamp in the oven fails and needs replacement, proceed as follows. (Bulb replacement is not covered by Fig.
Page 30
Other Useful Information (Cont.) Service, repairs and spare parts • Besides keeping the oven clean, regularly inspect the control dials and heating element. • If the appliance is damaged, do not attempt to repair it yourself. If it requires repair or service, please contact our after sales support centre to arrange for examination and repair.
Page 31
Other Useful Information (Cont.) Technical specifications Model HV-C60OV-S Oven cavity capacity (gross) 73 L Product dimensions (H)595 x (W)595 x (D)560 mm Aperture dimensions (H)589 x (W)560 x (D)550 (min) mm Weight approx. 32 kg Oven light bulb Halogen lamp, 230 V~, 25 W, 300°C...
Page 32
Other Useful Information (Cont.) Responsible disposal Packaging materials are recyclable. Please dispose of them responsibly for recycling. At the end of its working life, do not throw this appliance out with your household waste. Electrical and electronic products contain substances that can have a detrimental effect on the environment and human health if disposed of inappropriately.
Page 33
Other Useful Information (Cont.) Licensed installer/electrician details Please ask your licensed installer/electrician to fill in the details below so you have them on record should you need to contact the installer in the future. Proof of professional installation is also required for warranty claims. Please fill in the details below: Name of licensed installer: ............
Page 34
This page has been left blank intentionally. After Sales Support 34 34 (AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support...
Page 35
This page has been left blank intentionally. After Sales Support (AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support...
Page 36
Warranty returns Should you for any reason need to return this product for a warranty claim, make sure to include all accessories with the product. Product does not work? If you encounter problems with this product, or if it fails to perform to your expectations, make sure to contact our After Sales Support Centre on (AU) 1300 886 649 or (NZ) 0800 836 761 for advice.
Need help?
Do you have a question about the HV-C60OV-S and is the answer not in the manual?
Questions and answers