Advertisement
Other Useful Information (Cont.)
Removing the oven door for cleaning
Removing the oven door and the glass panel inside the door enables full
access to the entire oven cavity for easier cleaning and maintenance.
• Before you start, place some soft, padded material on the floor or benchtop.
• Open the oven door completely and have a
look at the door hinges (Fig. 6). The hinges
(A) have two movable latches (B) on them.
If you raise both these latches, the hinges
are released from the oven housing.
• Close the door to an angle
approximately 15°.
• With both hands, grip the sides of the
door at the centre and then incline it
slightly towards the oven cavity and then
pull the door gently away from the oven
cavity (Fig. 7).
IMPORTANT:
supported at all times and that you place it on
some padded material while cleaning it.
• Place the door flat on the prepared soft
material for cleaning.
• Clean the oven glass door only with a damp cloth and a small amount of
mild detergent. Make sure the cloth is clean and does not contain residues
of other cleaning products.
• If you want to remove the inner glass panels for cleaning while you have
taken the door off the oven, please refer to the next page for instructions.
• To refit the door, carefully slide the hinges back into their slots and open the
door fully.
IMPORTANT:
before closing the door.
• The latches must be closed back into their original positions before closing the door.
• Take care not to dislodge the hinge locking system when removing the door, as the
hinge mechanism has a strong spring.
• Do not immerse the door in water at any time.
26 26
(AU) 1300 886 649 (NZ) 0800 836 761 |
Make sure that the door is
The movable latches (B) must be closed back into their original positions
After Sales Support
Fig. 6
Fig. 7
CAUTION!
B
A
tempo.org/support
Advertisement
