Installation
Pass the PV L1 cable from the PV inverter through the 200 A CT as shown below. The side
b
with the markings P1 and K on the CT faces the PV inverter, and the side with the L and P2
faces the SE Box.
CAUTION
y Make sure the CT sensor's direction is correct.
y Fix the CT sensor and the L1 cable with a cable tie and position the CT sensor inside of the
SE Box.
INFO
Make sure the CTs are facing the proper direction as described in this manual. A CT will show a
negative current if installed in reverse.
58
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
PV
inverter
Due to our policy of continuous product innovation, some specifications may change without notice.
L1
L2