Cmp Only - TE Connectivity CBP-5T Mk II Customer's Manual

CMP Only

The following safety items apply only to CMP models.
Caster Wheels
The CMP is mounted on four swivel casters. The rear two casters are lockable. Two people are required
when moving the machine as it is heavy.
Seismic Restraints
Protection from unwanted motion during an earthquake can be achieved by bolting the frame to the floor.
This can be done in many ways, two of which are described here.
1. Drill holes through the lower frame tube on the right and left sides of the machine. Secure Eye-Bolts to
the holes. Anchor similar Eye-Bolts into the floor below the machine. Secure the machine to the floor
using chain or cable.
2. Fabricate steel angle plates to bolt to the lower frame tube at the left and right sides of the machine.
Anchor the angle plates to the floor.
NOTE
A seismic restraint kit is available from TE upon request.
Frame Construction and Weight Distribution
The frame is constructed of tubular steel welded together and supports the very heavy press frame.
NOTE: CMP-10T Mk II shown,
CMP-5T Mk II similar
Top Horizontal Frame
Plates, Preferred Fork
Lifting Point
Bottom Frame, Alternate
Fork Lifting Point
Rev C
Figure 5
409-35001
8 of 92