Recording Operations - Digimerge DGR204 Installation & User Manual

4.2 Recording Operations

This section details the various recording methods available – Manual, Timer, Alarm, and External.
Before commencing with the recording function, please configure the recording settings properly
according to your needs.
4.2.1 Manual Recording
When the DVR is in live display mode, take the following steps to start recording:
(1) In live display, press the REC button
corresponding programmed recording settings. The monitor should display a flashing REC
message and the REC button
(2) Press the STOP button
(3) To access just recorded video, please refer to section 4.4 for more details.
4.2.2 Timer Recording
Timer recording provides two periods of time each day in a weekly table which programs the DVR
Start and Stop recording at specified times. Please take the following steps to program the
scheduled recording.
(1) Press the Setup button
(2) Select the TIMER/ SEQ/ TITLE and press the Enter button
TITLE page.
(3) Select the TIMER－SET.
(4) Press the Enter button
(5) ● You can set up by using the "<" button
day/hour/minute and use the "
day/hour/minute you wish.
● You can also set up by using the Shuttle Ring and the Jog Dial.
"<" button ,
and is the equal of the "v" button
● The time is displayed in a 24-hour clock format.
(6) After scheduling is completed, press the Enter button
select CANCEL to leave the page without saving the settings.
(7) To activate the programmed recording schedule, set the REC ENABLE to ON. As the
scheduled recording is on, the red indicator of the Timer Record
deactivate it, set to OFF.
(8) Press the STOP button
to continue the scheduled recording, press the REC button
to record video into a hard disk drive with the
will light up indicating the DVR is in the recording status.
to stop recording any time.
to enter the MAIN MENU.
to enter the REC SCHEDULE table.
^
" button
is the equal of the ">" button
.
during the scheduled recording to stop it at any time. If you wish
18
to enter the TIMER/ SEQ/
and the ">" button to locate the specific
and the "v" button
is the equal of the
, is the equal of the "
and set OK to save the setting or
will be on as well. To
to proceed.
to set the
^
" button