Table of Contents
Advertisement
4. Setting the jumper of your hard disk driver. The way to set the jumper
of the drive varies between manufacturers; please refer to the
instructions on the driver to set the jumpers in the master position.
5. Attach the interface connector and the power connector to the drive.
Please note the red lining of the IDE cable and the red wire of power
cable must line up side by side.
6. Place the HDD inside mobile rack, Use four of the provided screws.
7. Place the top cover back to the carrier body by sliding forward to
secure.
8. Slide the carrier body back in the mobile rack.
50
Advertisement
Table of Contents
