Table of Contents
Advertisement
2.
Remove the payload, release the bottom clamp (18), raise the
bottom stage (6) to its maximum height. Both stages must be
fully extended and the payload removed.
3.
Tip the pedestal over and carefully lay it on its side.
18
14
Strut
Factory Fitted
Supplied loose with Pedestal
Available to purchase
14
Payload / Force
Part No.
18
30-55 kgs / 450N
55-70 kgs / 600N
0-30kgs / 270N
4.
Unscrew and remove the centre end plug (24) from the base of the
telescopic column.
5.
Withdraw the gas strut (24) from the column.
6.
Fit the new gas strut, cylinder end first, carefully guiding it up
through the column until it is fully engaged.
7.
The strut is correctly fitted when the thread on the end plug (23)
can be started in the column without compressing the strut.
8.
Tighten the end plug (23).
9.
Carefully stand the pedestal upright.
24
23
WARNING! Make sure that the pedestal is at it's
3328--305
!
maximum height before tipping it over and removing the
3328-385
centre plug. If not do not attempt to remove the nut (23)
as the strut will be ejected under pressure.
3328-307
Maintenance
24
23
27
Advertisement
Table of Contents
