Flashing Control Board Firmware
Firmware is uploaded to the Control Board over SCI using C2Prog software. Use the following steps to load new firmware onto
the control board.
1. Download and install C2Prog_v1.7e-b5721 from
02 Tools > C2000Prog > C2Prog_v1.7e-b5721.zip
2. Launch C2Prog and configure as shown:
a. Set Target to 28375,7,9S and set Options to 20MHz.
b. Enable only Smart Sector Selection.
AEM Performance Electronics
2205 W 126th Street, Unit A
Hawthorne, CA 90250
https://www.cascadiamotion.com/documents
Page 20 of 23
Phone (8am-5pm M-F PST): 310-484-2322
Fax: 310-484-0152
sales@aemev.com
tech@aemev.com
> General Link to All Files >