Table of Contents
Advertisement
AEM Performance Electronics
Phone (8am-5pm M-F PST): 310-484-2322
2205 W 126th Street, Unit A
Fax: 310-484-0152
Hawthorne, CA 90250
sales@aemev.com
tech@aemev.com
ENCODER BREAK OUT
The encoder break out connection serves two purposes.
First is to connect to the encoder sensor itself.
Second is to provide an interface point for directly
programming the Control Board.
ENCODER
Plug 4 way connector into encoder sensor. Plug 6 way DTM
connector into encoder break out connection.
Note that encoder must be connected in order for the motor
to operate.
CAN 1/2
High speed CAN bus network into and out of the inverter. One
CAN lead will have 120 Ohm CAN termination plug installed.
Other open CAN connection should be connected to VCU CAN
2 for inverter control.
Leave the CAN termination plug in place if the inverter is the
node that's physically furthest away from the VCU.
Deutsch DTM plug and terminals included in kit.
HVIL
High Voltage Interlock Loop. Optional but highly
recommended.
ORG/RED is HVIL In and ORG/BLK is HVIL Out. Connect
accordingly for VCU being used.
Deutsch DTM receptacle and terminals included in kit.
Page 15 of 23
Advertisement
Table of Contents
