Remove the remaining screw, remove the Tesla board, put the
AEM Control Board in place, and secure with the one hold
down screw. Line up the other Control Board mounting holes
with the EMI shield and then lightly snug up the screw. This will
allow adjustment of the Control Board and shield while
remounting.
Position the Control Board back in the inverter and plug in
connectors to hold it in place.
Align the screw holes and install the mounting screws. Be sure
to tighten the one shield mounting screw. Double check that all
connectors have been plugged in.
Control Board installation complete. Re-install inverter cover, HV cables, all mounting screws and orange plastic protective cover.
Installation is the reverse of removal.
AEM Performance Electronics
2205 W 126th Street, Unit A
Hawthorne, CA 90250
Page 13 of 23
Phone (8am-5pm M-F PST): 310-484-2322
Fax: 310-484-0152
sales@aemev.com
tech@aemev.com