Table of Contents
Advertisement
Gently move the end of the cover up/down & left/right to
release it from the sealing o-ring. While doing this, give
attention to also disengage the inverter connector from the
end of the cover. Once fully released, completely remove the
cover by sliding it straight off.
Start the removal of the stock Tesla board by removing the
screws indicated (green).
Leaving the connectors plugged in will hold the
board in place allowing for easier removal once all
the screws have been removed.
Carefully unplug all the connectors and then remove the board.
The board will come off with a metal EMI shield attached
behind it.
AEM Performance Electronics
2205 W 126th Street, Unit A
Hawthorne, CA 90250
Page 12 of 23
Phone (8am-5pm M-F PST): 310-484-2322
Fax: 310-484-0152
sales@aemev.com
tech@aemev.com
Advertisement
Table of Contents
