Daiichi Electronics SQLC-110L Instruction Manual page 44

◆ 136 Power factor operation method
The operation method of power factor measurement can be selected from
0 (instantaneous measurement) and 1 (averaging operator in a demand
time interval).
In case it is set as "1 (averaging operator in a demand time interval)",
power factor measurement is calculated from the operation method of a
power demand time interval and a demand active power meter.
Selection by ＋ and － , set value is updated by SET .
Default setting：0 (Instantaneous measurement )
0：Instantaneous
measurement
(4) 141H to 14A Harmonic detection setting
Set the high-alarm value of each harmonic (current, voltage) measurement factor, factor,
5th conversion detection characteristics, and average time interval is performed.
141H
Current distortion
factor
upper limit
RESET/
SHIFT
◆ 141H Current distortion factor upper limit,
145H Voltage distortion factor upper limit.
Set the high-alarm value of distortion factor (current, voltage).
Setting range. Current：5 to 100％ (1％ step)
Voltage：1.0 to 20.0％ (0.1％ step)
Selection by ＋ and － , set value is updated by SET .
Default setting：OFF [Non use] (Current, Voltage)
◆ 142H Current 5th conversion content upper limit,
146H Voltage 5th conversion content upper limit.
Set the high-alarm value of 5th conversion content
(current, voltage).
Setting range. Current：5 to 100％ (1％ step)
Voltage：1.0 to 20.0％ (0.1％ step)
Selection by ＋ and － , set value is updated by SET .
Default setting：OFF [Non use] (Current, Voltage)
◆ 143 Current nth content factor,
147 Voltage nth content factor.
Set the factor (order) of nth content (current, voltage).
An order can be selected from n= 3, 4, 5, 7, 9, 11, 13, 15.
Selection by ＋ and － , set value is updated by SET .
Default setting：5th (Current, Voltage)
◆ 144H Current nth content upper limit,
148H Voltage nth content upper limit.
Set the high-alarm value of nth content (current, voltage).
Setting range. Current：5 to 100％ (1％ step)
Voltage：1.0 to 20.0％ (0.1％ step)
Selection by ＋ and － , set value is updated by SET .
Default setting：OFF [Non use] (Current, Voltage)
＋
Averaging operator
1：
＋
in a demand time
－
interval
－
142H
RESET/ Current 5th
SHIFT conversion content
upper limit
147
Voltage nth
content factor
RESET/
SHIFT
148H
Voltage nth
content
upper limit
New setting
Setting No.
143
RESET/ Current nth
SHIFT
content factor
146H
Voltage 5th
RESET/
conversion content
SHIFT
upper limit
149
RESET/ 5th conversion
SHIFT detection
characteristics
Current distortion factor upper limit
43
Current setting
Power factor operation method
144H
RESET/ Current nth
SHIFT content
upper limit
145H
Voltage distortion
RESET/
factor
SHIFT
upper limit
14A
RESET/ Average time
SHIFT interval
Setting factor New setting
Setting No.
Current setting
Setting factor New setting
Setting No. Current setting
Voltage nth content factor
SQLC-220-086
RESET/
SHIFT