Support Pad Installation And Positioning - Permobil BodiLink Head Support Operation Manual

SUPPORT PAD INSTALLATION AND POSITIONING

IMPORTANT! Support pad installation and positioning should be completed with hardware adjustments, detailed on
the following pages.
Support Pad Installation
1
Align the ball link (A) and the ball ring (B) with the ball
receiver (C).
2
Loosely engage the screws (D) and the safety washers (E)
with the ball receiver (C).
3
Tighten the screws (D).
4
Continue with SUPPORT PAD POSITIONING.
Support Pad Positioning
Note: Premium BodiLink head supports have a preformed curvature for optimal posterior contact, and 10-18" W pads have 2
points of adjustment for additional lateral support.
1
Loosen all the hardware adjustment point screws, allowing
for the full articulation of the head support to a desired
position. Loosening the screws (F) around the ring (G) will
allow support pad orientation adjustment.
2
PREMIUM PADS: To access the wing adjustment screws (HS)
on the 10" - 18"W pads, partially unzip the locking zippers
under the cover flaps. The screw heads are accessible in the
channels.
BASIC PADS: Mold the pad by bending with hands or over a
firm surface. (Basic pads are not shown.)
WARNING: If the screws (F) are not evenly tightened all
around the ring (G), unwanted movement may occur.
3
Continue with "SUPPORT PAD - HARDWARE ADJUSTMENT". If
using the Corpus Headrest Support Pad, see also "ADAPTER
PLATE FOR CORPUS".
Note: Premium BodiLink head support pads may be flipped 180º.
BodiLink Head Support Operation Manual
16
1
E
D
F
H
Shown: 14" x 5"L Premium
Support Pad (without cover)
and PT Hardware
C
B
A
2
G