Installation - Permobil "B" Mounting Block - Permobil BodiLink Head Support Operation Manual

INSTALLATION - PERMOBIL "B" MOUNTING BLOCK

For Permobil Corpus Back Support (20" height) using the Permobil "B" Mounting Block.
1 If the head support hardware stem is inserted in the
mounting block (B), turn the knob (A) counterclockwise to
release it. Remove the hardware stem; set aside.
2 Using the 5mm hex key, loosen the screws (C) to release
the washers (D), and the double nuts (F) from the mounting
bracket (E).
3
Move the back support cover (not shown), allowing access
from both sides to the head support holes on the back
support shell (G).
4
Align the mounting bracket (E) with the head support holes
on the back support shell (G) and the double nuts (F).
5
Replace the screws (C) and the washers (D) and tighten.
6 Replace and secure the back support cover.
7
Insert the hardware stem into the mounting block (B) and
turn the knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" of the hardware
stem is completely through the bottom of mounting block (B) at
all times. See the warning in the "Important Safety Information"
section in this manual.
Note: See SUPPORT PAD installation, positioning and adjustment
instructions in this manual to make final adjustments.
Alternate options when using the Permobil "B" Mounting Block.
1
Remove the screws (G) and the washers (H) on the mounting
block (B).
2
Align the mounting block (B) with the alternate holes on the
mounting bracket (E).
3
Replace the screws (G) and the washers (H) and tighten.
E
B
BodiLink Head Support Operation Manual
Note: If needed, an additional Corpus Seating System accessory rail can be
attached to the inner face of the mounting bracket, using the countersunk holes
on the mounting bracket. Access the countersunk holes, using the instructions
to the left. Refer to the instructions provided with the accessory rail for proper
attachment and use.
G
H
F
G
E
F
D
Standard and Alternate Mounting Block
Placement on the Mounting Bracket
An accessory rail attached to the Mounting Bracket
11
E
D C
A
B
C
Countersunk Holes