Support Pad - Gt Hardware Adjustment - Permobil BodiLink Head Support Operation Manual

SUPPORT PAD - HARDWARE ADJUSTMENT
GT Hardware Adjustment
Note: Lateral Style GT Hardware (without additional link added)
is shown. Mid-line GT hardware does not have angle adjustment
points.
Note: Adjustments should be made simultaneously with pad
positioning adjustments.
1
Loosen all the hardware adjustment point screws,
allowing for the full articulation of the head support to
the desired position.
2
Hold the hardware and the pad in place while tightening
each joint.
Note: As the gear teeth engage, adjustments may affect each
other and may require compensation from the other joints
before the final tightening.
WARNING: Make sure that the teeth on all link joints
are properly aligned and engaged before final tightening.
Failing to do so could cause wear on the teeth, leading to
parts slipping out of adjustment or hardware failure. (GT
Hardware only)
Gear Teeth Alignment
D
D
BodiLink Head Support Operation Manual
18
(A) = Angle/Lateral Offset
(D) = Depth
(H) = Height
14W x 5L pad
A
A
H