Table of Contents
Advertisement
6-14-7 EDACS TRUNKING MANUAL TEST-REPEATER SIMULATOR
Enter ing the Repeater Simulator causes the CO M- 120C to per for m an FM- Zer o
oper ation to adjust the Receiver 's DC offset to zer o.
" Doing FMZ...please wait" .
While in the Repeater Simulator and the Radio is not tr ansmitting, or the r epeater is not
calling the Radio, the Site ID message is continuously tr ansmitting.
the Repeater Simulator is looking for a Call ( or Login) r equest fr om the Radio.
the r equest is found, the Repeater Simulator allows the Radio to tr ansmit ( until the
Radio r eleases) . The G r oup/Logical ID's ar e captur ed ( and displayed) when the G r oup
Call is made ( and used to call a Radio) .
simulator and the ID's captur ed.
softkey) wher e the r epeater simulates a Radio calling the Radio Under Test.
mode, ther e ar e softkeys to disconnect and r etur n back to the idle state.
1. CH#:
This field is used to change the
EDACS Repeater Simulator
Wor king Channel, as specified
by the Channel Number pr e-
pr ogr ammed in the Setup
Scr een. Value r ange: 1 to 20.
The cor r esponding RF
Fr equencies ar e shown in the
RF fields as the CH# field is
edited. This only sets the
Wor king Channel. The Contr ol
Channel is taken fr om the
Setup Scr een and must be
changed ther e if necessar y.
If the Band field is set to
'Manual' ther e is no channel
number to edit.
the channel Band mode.
2. Band:
This field shows the channel for mat for the Repeater Simulator Wor king Channel.
Valid values ar e: 800 MHz, 900 MHz, USER or Manual. Display- only field. If
'Manual' is displayed, the RF Fr equencies have been set manually in the Repeater
Simulator . All other values ar e taken fr om the pr e- pr ogr ammed logical channels
fr om the Setup Scr een, accor ding to the channel number set in the CH# field.
Ther e is also a mode of oper ation ( activated by
CH #: 2
RF:
Atten:
Input:
Group ID 273
Logical ID
Call Type: SYSTEM ALL
RF Power:
RF Error Freq:
Deviation:
AF Frequency:
Distortion:
CALL
The PRG M Soft Function Key F3 may then be used to r etur n to
6- 83
The scr een displays the message:
A Radio's Login is also decoded by the
EDACS REPEATER SIMULATOR
Band: USER
RECEIVE
812.2125
MHz
0 dB
T/R
1
837.8 mW
0.210 kHz
0.78 kHz (D)
300 Hz
2.3 %
DISC
PRGM
SECTION 6
OPTIONS
In this idle mode,
When
In this
Extended Meas:
GENERATE
RF:
857.2125
MHz
Level:
-40.0 dBm
Output:
T/R
Status: IDLE
Message:
DATA
Mod Source:
DATA
FM
Deviation:
3.2 kHz:
Subaud dev:
0.70 kHz
Sinad:
RETURN
0061601
Advertisement
Table of Contents
