RAB LESLIE Instructions

INSTRUCTIONS
LESLIE® INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
rmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.
WALL MOUNTING
Mount to a weatherproof Junction Box (not supplied) and Cover
Plate (not supplied) as shown in Fig. 1. Apply weatherproof silicone
sealant around the edge of the Junction Box. This is especially
important with an uneven wall surface.
1. Thread fi xture into Cover Plate. Use silicone sealant or Tefl on®
tape around the thread of the arm.
2. Connect wires as shown in the wiring section (Fig. 3).
3. Attach Cover Plate to Junction Box.
4. Aim fi xture in the desired direction and tighten locknut and
Arm Screw.
GROUND MOUNTING
Mount to a Mighty Post (RAB Cat# MP19) as shown in Fig. 2.
1. Thread fi xture into Mighty Post Cap (ordered separately). Use
silicone sealant or Tefl on® tape around the thread of the arm.
2. Connect wires as shown in the wiring section (Fig. 3). Push all
wires inside the Mighty Post Cap (ordered separately).
3. Place Mighty Post Cap on the Mighty Post.
4. Aim fi xture in the desired direction and tighten locknut and
Arm Screw.
LESLIE®
Fig: 1
Cover Plate
(not supplied)
Fig: 2
Arm Screw
Junction Box
(not supplied)
Arm Screw
Mighty Post and Cap
(ordered separately)